Merck B63

ASTM Aluminum base and ASTM Aluminum intermediate channels sized to properly support all components and prevent any pulsating or oil canning - Underside of Unit Base coated with minimum 2” sprayed on foam insulation

(2) Multistack W/C Modular Chiller – Variable Speed – Model MSS050VFactory witness testing for fit and finish, air pressure for piping, and continuity for electrical and control wiring (3) Custom Air Handling Units and (1) Custom Energy Recovery Units AHU’s and ERU are provided complete with Fans, Filters, Coils, Dampers, Humidifiers, Lights, etc.Dedicated fan coil units were provided for each electrical/UPS/CSR room, including the substation room. Units shall be sized for the load in the space, with an appropriate additional safety factor – QTY (4) Carried at this time in pricingMultiple fan coil units were  provided for the mechanical room and equipment platformGlycol Chilled Water System(1) B300 Series B ASME Bladder Tank (80 GAL)

(2) B&G Model ‐ QSU‐144‐2 Shell‐and‐Tube Heat Exchanger. Sized to Heat 400gpm Water from 110degF to 140degF Using 15psig Steam. Heat Exchanger Rated for Full Vacuum(1) B300 Series B ASME Bladder Tank (80 GAL) (1) B&G RL‐6F Rolairtrol Air Separator

(2) P62 ‐ B&G Model – AP62 Plate Heat Exchanger ‐ Sized to Cool 950gpm Water from 99degF to 87degF Using 1145gpm Water @ 85degF.

(1) Spirotherm VDT model Air Dirt Separator, manual bypass around SeparatorIn-line flow meter (Provided by Siemens)

(2) P62 ‐ B&G Model ‐ AP62 Plate Heat Exchanger ‐ Sized to Cool 530gpm Water from 61degF to 48degF Using 662gpm Water @ 46degF. 10psid Max. Both Sides. 0% Excess Surface Selected(1) B165 Series B ASME Bladder Tank (44 GAL)(1) B&G RL‐10F Rolairtrol Air Separator

(1) ZR75VSD+-P-10.4-60-460V Atlas Copco Variable Speed Oil-Free Screw Compressor Model: ZR 75 VSD+(1) ER275 - ER275-460V-60-ANSI ENERGY RECOVERY CONTROL UNIT(2) BD250+ASME  440V CSA-UL  -40F ATLAS COPCO HEATED BLOWER PURGE DESICCANT DRYER(1) LV 400-200 – Wet Receiver, 400 Gallon Vertical Air Receiver, Carbon Steel, Primer

EAS has included Supply Air, Return Air, Outside Air, Exhaust Air and Relief Air ductwork for the AHU’s and Exhaust Fan located on the Mezzanine Level to the boundary of EAS SuperSkids  Duct distribution systems will include duct-mounted airflow measuring stations in the duct mains.All duct insulation is included

EAS has included the following Electrical Scope:Provision and installation 400 amp/480V/Distribution Panelboard equipment.)All distribution power within the boundaries of EAS SuperSkids to be provided factory installed by EAS.

Siemens subcontract to be held by others.